Best Sub Zero Fridge Vacuum Condenser Message

Included in this kit is a 24 inch flexible hose attachment for hard to reach areas like down in your dryer lint trap or under your refrigerator…… Also, included is one 28 inch long Flexible Dryer Vent and Refrigerator Brush, this brush is on twisted wire and flexible and the benefit of that is it will easily conform to the shape of your dryer lint trap…… If your dryer vent is badly clogged use the brush first to get the bulk out then use the vacuum crevice tool.(Doing this will cut down on clogs in your crevice tool even though the suction end of this tool is wide enough to have good airflow and still be small enough for most dryer “Lint traps” (end of tool is 15mm width) …. Both the hose attachment and brush are flexible and can bend back straight. They will arrive flexed/curved for easier shipping but will straighten out or bend to your application of use. To assemble the crevice tool run warm water over the ends of the hose which will make inserting ends easy. The length of vacuum tool may vary by 1/2 inch. ** ….Please make sure that your vacuum hose has a diameter of 1 ¼ inches or less.** Some Shark vacuum cleaners are 1.5 inches which is too big for this crevice tool……This tool will fit most vacuum hoses, but please measure the end of your hose to make sure it will fit….. Does not fit Dyson vacuum cleaners…..Here is a partial list of Shark vacuums that it will fit: Shark Duo Clean, Shark Ion Flex, Shark Flex, Shark Rocket. — The Shark Navigator and Swivel Steering – it will fit inside the hose but is not a tight fit, but will work… Shark Professional it will fit but you need to push it on. Does not fit Newer Bissells (unsure of older Bissells -please measure). If you are not sure if it will fit your vacuum please ask a question and we will respond.